This reagent is for research use only: serum or plasma test principle: Lipoxins kit is a solid-phase sandwich enzyme-linked immunosorbent assay (ELISA). Standards with known concentrations of Lipoxins and samples with unknown concentrations are added to microwell enzyme plates To be tested. First, Lipoxins and biotin-labeled antibodies were incubated at the same time. After washing, HRP labeled with avidin was added. After incubation and washing, the unbound enzyme conjugate is removed, and then substrates A and B are added to act simultaneously with the enzyme conjugate. Produce colors. The color depth is proportional to the concentration of Lipoxins in the sample. Bring your own material distilled water. Sampler: 5ul, 10ul, 50ul, 100ul, 200, 500ul, 1000ul. Oscillator and magnetic stirrer etc. Safety Avoid direct contact with the stop solution and substrates A and B. Once exposed to these liquids, rinse with water as soon as possible. Do not eat, drink, smoke or use cosmetics during the experiment. Do not use your mouth to absorb any ingredients in the kit. Handling precautions Reagents should be stored according to label instructions, and returned to room temperature before use. The sparse standards should be discarded and cannot be stored. The slats not used in the experiment should be immediately returned to the packaging bag, sealed and stored to avoid deterioration. Unused other reagents should be packed or covered. Do not mix reagents of different batches. Use before warranty. Use a disposable pipette tip to avoid cross-contamination, and avoid using a sampler with a metal part when drawing the stop solution and substrates A and B. Use a clean plastic container to prepare the washing solution. Mix all components and samples in the kit thoroughly before use. When washing the enzyme-labeled plate, it should be fully patted dry. Do not put the absorbent paper directly into the enzyme-labeled reaction well to absorb water. Substrate A should evaporate to avoid opening the lid for a long time. Substrate B is sensitive to light and avoid prolonged exposure to light. Avoid contact with hands, it is toxic. The OD value should be read immediately after the experiment is completed. The order of adding reagents should be the same to ensure that all wells are incubated for the same time. Perform the incubation operation according to the time, the amount and order of the liquid indicated in the instructions. Sample collection, processing and storage methods Serum-avoid any cell stimulation during the operation. Use test tubes free of pyrogens and endotoxins. After collecting blood, centrifuge at 1000 Ã— g for 10 minutes to separate the serum and red blood cells quickly and carefully. Plasma ----- EDTA, citrate, heparin plasma can be used for detection. Centrifuge at 1000 Ã— g for 30 minutes to remove particles. The cell supernatant was centrifuged at 1000 Ã— g for 10 minutes to remove particles and polymers. Storage ------ If the sample is not used immediately, it should be divided into small parts and stored at -70 â„ƒ to avoid repeated freezing. If possible, do not use hemolysis or hyperlipidemia. If there are a large number of particles in the serum, centrifuge or filter before testing. Do not thaw at 37 Â° C or higher. Thaw at room temperature and ensure that the sample is thawed evenly and adequately. Reagent preparation standards: Serial dilutions of standards should be prepared during the experiment and cannot be stored. Before dilution, the standard was mixed by shaking. Dilution of washing buffer (50 Ã—): 50-fold dilution with distilled water. Before use, mix all reagents thoroughly. Don't make the liquid generate a lot of foam, so as to avoid adding a large number of bubbles during sample addition, which will cause errors in sample addition. The number of slats required is determined by the number of samples to be tested plus the number of standard products. It is recommended to make multiple holes for each standard and blank hole. Each sample is determined according to its own quantity, and those that can use multiple holes can be used as much as possible. Add 50ul of the diluted standard to the reaction well and 50ul of the sample to be tested in the reaction well. Immediately add 50ul of biotin-labeled antibody. Cover the membrane plate, gently shake and mix, and incubate at 37 Â° C for 1 hour. Shake off the liquid in the wells, fill each well with washing liquid, shake for 30 seconds, shake off the washing liquid, pat dry with absorbent paper. Repeat this operation 3 times. If washing with a plate washer, the number of washes is increased once. Add 80 ul of streptavidin-HRP to each well, gently shake and mix, and incubate at 37 Â° C for 30 minutes. Shake off the liquid in the wells, fill each well with washing liquid, shake for 30 seconds, shake off the washing liquid, pat dry with absorbent paper. Repeat this operation 3 times. If washing with a plate washer, the number of washes is increased once. Add 50ul of substrate A and B to each well, mix gently by shaking, and incubate at 37 Â° C for 10 minutes. Avoid light. Remove the enzyme labeling plate and quickly add 50ul of stop solution. After adding the stop solution, the results should be measured immediately. The OD value of each well was measured at a wavelength of 450 nm. The results above the No. 6 standard are non-linear, and accurate results cannot be obtained based on this standard curve. Kit performance 1. Sensitivity: The minimum detection concentration is less than No. 1 standard. Linearity of dilution. The correlation coefficient between the linear regression of the sample and the expected concentration is 0.990. 2. Specificity: Does not react with other cytokines. 3. Repeatability: The coefficients of variation within and between plates are less than 10%. Judgment and analysis of results 1. Instrument value: read the OD value of each well on a microplate reader with a wavelength of 450 nm. 2. Take the absorbance OD value as the ordinate (Y), and the concentration of the corresponding Lipoxins standard product as the abscissa (X). To make the corresponding curve, the Lipoxins content of the sample can be converted from the standard curve to the corresponding concentration according to its OD value. 3. Detection value range: 0-24ng / ml 4. Sensitivity: 0.1 ng / ml Y109019 Human interleukin-18 (IL-18) ELISA kit Human IL-18 ELISA KIT 96T / 48TY109020 Human connective tissue growth factor (ctgf) ELISA reagent Human Connective tissue growth factor ELISA Kit 96T / 48TY109021 Human Platelet Factor4 ELISA Kit 96T / 48TY109022 Human Tissue factor ELISA Kit Human Tissue factor ELISA Kit 96T / 48TY109023 Human C-reactive protein (CRP) Human CRP ELISA Kit 96T / 48TY109024 Human Type III Procollagen Amino Terminal Peptide (PIIINT) Human PIIINT ELISA Kit 96T / 48TY109025 Human Platelet Activating Factor (PAF) ELISA Kit Human PAF ELISA Kit 96T / 48TY109026 Low Human Oxidation Density lipoprotein (OxLDL) Human OxLDL ELISA Kit 96T / 48TY109027 Human platelet-derived growth factor (PDGF) Human PDGF ELISA Kit 96T / 48TY109028 Human thrombomodulin (TM) ELISA kit Human thrombomodulin ELISA Kit 96T / 48TY109029 Human fibrinogen degradation Product (FDP) Human FDP ELISA Kit 96T / 48TY109030 Human Plasminogen Activator Inhibitor (PAI) Human PAI ELISA Kit 96T / 48TY109031 Human Plasminogen Activator Inhibitor 1 (PAI-1) ELISA Kit Human PAI-1 ELISA Kit 96T / 48TY109032 Human Intercellular Adhesion Molecule-3 (ICAM-3) Human ICAM- 3 ELISA Kit 96T / 48TY109033 Human Intercellular Adhesion Molecule-2 (ICAM-2 / sCD102) Human ICAM-2 / sCD102 ELISA Kit 96T / 48T
Kraft Paper Bag
Kraft Paper Bag is main kind bag for shopping or food bag.
They usually have two colour ,brown and white .
All of the kraft paper bag is uncoated material ,and it is the popular recycle material in the packaging. So many brands only purchase uncoated paper bag .
The kraft paper `s material thickness can be 80gsm-300gsm for the bag ,and we can use different handle for your bag,with custom printing.
If you need kraft paper bag,please email us freely.
Kraft Paper Bag
Kraft Paper Bag,Custom Kraft Paper Bag, Brown Kraft Paper Bag,Snack Kraft Paper Bag
Huizhou Cailang Printing Products Co.,Ltd. , https://www.paperboxs.nl