Bora cutting guide-vertical stripes on the cutting surface

When cutting the material at a certain angle, the cutting surface should not have vertical stripes, right? However, such stripes are not uncommon. The main reason for the vertical stripes is that the cutting material is not clamped correctly.

When cutting paper, each piece of paper will have a slight height change, and when accumulated, it will become a larger change. The cause of the height change may be due to the ink on the paper during printing, or it may be caused by the different thickness of the paper itself.

When a pile of material to be cut is clamped on the cutting machine, the upper part is always pressed tighter than the lower part. The upper part is usually subjected to excessive clamping force, because in theory, the entire compression area becomes smaller.

In this way, the accuracy of the cutting knife when cutting paper will be reduced. If you touch the cut paper stack at this time, you will easily feel the wavy texture. In short, excessive clamping pressure and height changes will form a certain pressure on the cutting knife. In extreme cases, the cutter may even break, because at this time the cutter will deviate from the area with excessive pressure to the front end. Therefore, at all times, it is necessary to ensure that the appropriate clamping pressure is selected to prevent the cutter from deviating due to excessive pressure.

Pola cutter has automatic clamping pressure adjustment function. The clamping pressure can be adjusted accurately and fully automatically according to the preset values ​​of various materials and cutting widths. If the height changes greatly, you can put a piece of flexible medium between the cutting material and the splint to compensate.

Matte PET Film/Pet Mylar Film :

Specification: 30mic-100mic

Use:Applicable to furniture ,printing labels etc

Appearance: low-gloss matte surface PET film

Item

Unit

Index

Test condition

Thickness tolerance

%

≤3

GB/T6682-2001

Transmittance

%

75±3

GB/T 2410-2008

Tensile strength

 

MD

Mpa

≥170

GB/T 1040.3

TD

Mpa

≥170

Elongation at

Break

MD

%

≥90

GB/T 1040.3

TD

≥90

Heat shrinkage (150℃30min)

MD

%

≤1.4

GB/T 16958-2008

TD

≤0.2

Haze

 

%

70±3

GB/T 2410-2008



Matte Pet Film

Pet Printing Film,Gloss Pet Film,Matte Pet Film,Pet Mylar Film

Shijiazhuang dadao Packaging materials Co , https://www.ddplasticfilm.com