Performance characteristics of electric blast drying oven:
â—† The temperature control system of this machine adopts microcomputer single-chip technology, temperature control, timing, over temperature alarm; â—† reasonable air duct and circulation system, so that the temperature uniformity in the working room changes little; â—† electric blast drying oven, using the first domestic streamline circle The arc design, the shell is made of cold-rolled steel plate, the surface is electrostatically sprayed; â—† The display is a dual-screen high-brightness digital tube display, the value is accurate and intuitive, and the performance is superior. The touch keys set the adjustment parameters;
Use method of electric blast drying oven:
â—† The temperature control sensor uses imported components of the capacitive type
1. If steam heating or water heating is used, the two heating ports of the special drying car (upper and lower ports) need to be connected to the port of water or steam by quick connection.
2. Put the materials into the oven attached to the vacuum oven evenly, insert the baking tray into the drying rack and push it into the drying oven.
3. Close the box door, the air release valve, and bolts on the box door, which can make the box door tightly combined with the silicone sealing strip.
4. Connect the vacuum pump to the vacuum valve, open the vacuum valve, and evacuate.
5. According to the performance of the vacuum pump, the limit value of the vacuum pump when the pressure gauge is pumped shall prevail.
6. After vacuuming, first close the vacuum valve. If the vacuum valve is not tight, please replace it, and then turn off or remove the power of the vacuum pump. (Prevent the phenomenon of reverse suction)
7. Observe the drying cycle of the materials of the firm at regular intervals, such as the calendar, temperature table, and the changes in the cabinet. If the pressure gauge index drops, there may be air leakage, and you can perform the pumping operation again. 8. After the drying is completed, first open the air release valve to release the gas inside, then open the drying door and take out the materials
PVC Crossbody Bag,Round Handbag,Barrel Shoulder Bag,Brown Crossbody Handbag
Dongguan Jinying Handbags Co.,Ltd , http://www.jinyingfashionbag.com